DMC AF8 Crimp and TH4 Crimp Tool Locator

Description

The DMC AF8, qualified to MIL-DTL-22520/1* and AS22520/1*, has virtually limitless application within the specified wire range of 12 through 26 AWG. Over a thousand turret heads are available to adapt the tool frame to your specific military or proprietary contact/wire combination. The 8 impression crimp, which is standard in the AF8, assures absolute maximum tensile strength with almost every closed barrel contact. Special indent configurations and gaging are available upon request.For proper operation, the tool must be mated with one of the following optional accessories: a military standard or non-military turret head (TH-XXX Part No. Series), a military standard or non-military positioner (TP-XXX Part No. Series), or an adjustable head (Part No. UH2-5). This is done simply by orienting the head in the keyed position, and by tightening the hex socket screws provided as part of the head.The precision ratchet controls cycling of the tool in both directions of handle movement. This assures the same accurate crimp every time. It's like having a quality control inspector at every work station.Positive crimp depth is controlled by an 8 position selector knob conveniently located on the tool frame. The operator simply dials the desired step for the wire being used. This setting can be secured by use of a locking pin or safety wire.A permanent dataplate is affixed to all turret heads and positioners. This plate lists specific contact part numbers, the corresponding position color code (for 3 position turret heads), and suggested selector depth settings for the wire size being used.The AF8 is approximately 9.75" x 2.5" x 1.25" and weighs 15 oz.Periodic gaging is recommended to insure accurate calibration. This can be done easily by setting the tool selector knob to position #4, and checking indenter closure with the M22520/3-1 Go/No-Go gage (DMC part no. G125). For a complete set of non-Mil-Spec Go/No Go gages for all selector settings, see DMC part no. 88-100.Other than keeping the unit clean and properly stored when not in service, no operator maintenance is required.
-AND-
Cage 11851, mil spec M22520/1-01, crimp tool frame for AF8 M22520/1-01 and contacts MS17803 (04, 07, 08), OS12814 Basic TYPE P&M, M21097 / 9-01Qualified to MIL-DTL-22520/1* and AS22520/1*M22520/1-03 (TH4) turret head is used with the M22520/1-01 (AF8) tool frame and adapts the tool frame to a particular application. The data plate on each turret head designates which contacts the turret accommodates and suggested selector depth settings for the wire size being used. Can also be used with these DMC Crimp Tools:WA27F Pneumatic Crimp Tool FrameAFE8B Battery Crimp Tool Frame
Came in to large lot and selling all!!!! Shipped with USPS